Monday, June 18, 2007

Cake Wording For Football Themed Party

Mini bar Clothing

Mini bar - Contact Cement


- Electric Jig

- Lija - Cream-colored leather sole

- Ointment

- Tacho golden


- Hammer

- Trinchet - Drilling - Screws

- cap nuts

- Wrench - Screwdriver

- Nails How to make a mini bar

1 - To replace the leg-I ro ta, cut a ribbon the same width and thickness with keyhole Lowering the ends to give the curved shape.

2 - With sanding block cut the ends and edges of the strip to achieve rounded shape.

3 - Stain the legs with cream-colored leather soles and black cream, alternating and blending products. Allow to aerate and polishing.

4 - Spread the cream leather and use a cotton cloth with a circular motion. Let dry and apply a second coat.

5 - Support the board on the back of the leather and pencil mark the outline. Cut out leaving a margin of 6 cm all around.


6 - Check the box corresponding to the sector plate and cut with utility knife, removing the piece.

7 - Put contact cement onto the table and on the reverse of the leather. Let airing 10 minutes and hitting the leather upholstery little, pressing a soft cloth to remove the air.



8 - Place concrete at the edges, back of the table and leather. Allow to aerate and paste. Reinforced with studs, inside out, the round edge.





9 - Assemble the legs holding them together first and then to the table with gold screws and nuts.

Basket

Thursday, June 7, 2007

Difference Asd And Pfo





Clothing
Cubrelornillos

• horn • Cement

• Metal Handle • Screwdriver



• Latex • Roll white fighter




home laundry Basket





1 - Clean the sponge iron detergent. Let dry and apply a coat of rustproof.



2 - black spray paint. Let dry thoroughly and apply a second coat.


3 - Cut a circle of MDF for the base. Placing the wheels at 5 cm from the edge. Make holes for the screws.

4 - Make a central hole. Fit the base at the bottom, and secured with a screw and a butterfly on the outside.

5 - Screw the wheels and secure base inside with screw caps.

6 - Cut the curtain along the seams, taking into account the perimeter of the frame plus 10 cm.

7 - 10 cm Remove excess and tie rod adjusting the final stage. Then measure the height of the basket and cut the curtain at the top.

8 - Put contact cement on the edge of the floor and the edge of the curtain. Allow to aerate and paste

9 - To hold the curtain to the studs, cut ribbon ties row of 15 cm and tie them in turn.


10 - Cut another circle of MDF 2 cm larger than the mouth of the frame. White latex paint with marbling Set the handle in the center.


Box

Saturday, June 2, 2007

Hide Wall From Certain Friends

Basket

te the box with a coat of white latex. Let dry thoroughly.


2 - Mask according to the scheme, first the longer sides of the lid.

3 - Brush with glaze the surface veining immediately painted over with blue.



4 - While drying, streak with undulating movements in a single pass. Allow to dry and change the tapes to paint the center stripe. 5 - Once dry the grain base, masking the central square and paint it blue. Remove the foil and allow to dry.

6 - Transfer the design onto the square. With linner Acrylic and gold fill the interior of the figure. Let it dry and give other hand.




7 - Mapping out the contours of the freehand square linner and gold. Let dry and varnish well.