Mini bar - Contact Cement
- Electric Jig
- Lija
- Cream-colored leather sole
- Tacho golden
- Hammer
- Trinchet - Drilling
- Screws
- cap nuts
-
Wrench - Screwdriver - Nails
How to make a mini bar
1 - To replace the leg-I ro ta, cut a ribbon the same width and thickness with keyhole Lowering the ends to give the curved shape.
2 - With sanding block cut the ends and edges of the strip to achieve rounded shape.
3 - Stain the legs with cream-colored leather soles and black cream, alternating and blending products. Allow to aerate and polishing.
4 - Spread the cream leather and use a cotton cloth with a circular motion. Let dry and apply a second coat.
5 - Support the board on the back of the leather and pencil mark the outline. Cut out leaving a margin of 6 cm all around.
6 - Check the box corresponding to the sector plate and cut with utility knife, removing the piece.
7 - Put contact cement onto the table and on the reverse of the leather. Let airing 10 minutes and hitting the leather upholstery little, pressing a soft cloth to remove the air.
8 - Place concrete at the edges, back of the table and leather. Allow to aerate and paste. Reinforced with studs, inside out, the round edge.
9 - Assemble the legs holding them together first and then to the table with gold screws and nuts.
Basket
0 comments:
Post a Comment