process of developing a four Ferrebus Select wood cuts
Stage 1 - Measures
| - Identify measures four
- Mark
box design - Establish central line
- Define measure the length of the pitch or arm
- Define measure the length of the blade or socket area
Mark - center of the mouth
- Make the hole and give termination
- Mark nozzle
- Cut nozzle area
|
Stage 2 - Outdoor Court
| - Set margin line
- Cut from the palette and the fingerboard
- Cut
box area - Court notes pitch and Paste
- lid rings
instruments |
Stage 3 - Cut
interior | - Cut the outer edge
- Give exterior finish - Sandpaper
- placement of internal bracing
- Drying reinforcements
- end of the fingerboard Measure and palette
- final Court
pitch arm terminations -
- Carving fork base pitch (nose)
|
Stage 4 - fingerboard and headstock
| Placement -
fingerboard Headstock Area -
- headstock slots cut
- side holes Measuring
- lateral drilling
- Termination - Lija
|
Stage 5 - Bridge Fourth
| - Court and preparation of the bridge
- Alignment and bonding of the bridge.
-
resonance Test Measurement and Cutting - the bone nut and bridge
- Placing the bones
- string alignment and completion of bones
temporary placement of the socket -
|
Outdoor Stage 6-Completion and completion.
| complete sanding exterior -
-
sealed timber seal - Sanding Painting
-
- four Polish and Shine Cleaning paint
- Notes and Placement
- bones Headstock Placement
-
- string tuning adjustment and final test
sound -
|
Bottom
0 comments:
Post a Comment